BATTERY COOLING FILTER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No. 2 HV battery intake filter removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	LKA/LDA system (for Mono camera type)	for Stereo Camera type: Click here for Mono Camera type: Click here
		Lane control system (for Stereo camera type)
		Parking support brake system*
		Pre-collision system (for Mono camera type)
		Pre-collision system (for Stereo camera type)
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here

*: When performing learning using the GTS.
Click here Click here

CAUTION:

Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

Click here
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.

Tech Tips

Use the same procedure for the RH and LH side.
The procedure listed below is for the LH side.

PROCEDURE

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Click here

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

Click here
REMOVE REAR SEAT CUSHION LOCK HOOK (for Fixed Seat Type)

Click here
REMOVE NO. 1 SEAT ARMREST CAP (for Fixed Seat Type)

Click here
REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)

Click here
REMOVE REAR SEAT BACK HOLDER (for Fixed Seat Type)

Click here
REMOVE REAR SEAT CUSHION ASSEMBLY LH (for Power Seat)

Click here
REMOVE REAR SEAT CUSHION LOCK HOOK (for Power Seat)

Click here
REMOVE REAR SEATBACK ASSEMBLY LH (for Power Seat)

Click here
REMOVE REAR DOOR SCUFF PLATE LH

Click here
REMOVE REAR SEAT SIDE GARNISH LH

Click here
REMOVE ROOM VENTILATION GRILLE SUB-ASSEMBLY LH
1. *A for Fixed Seat Type
  
  *B for Power Seat
  
  Detach the 6 claws to remove the room ventilation grille sub-assembly LH.
REMOVE NO. 2 HV BATTERY INTAKE FILTER
Tech Tips

If the message "Maintenance Required for Traction battery Cooling Parts See owner's manual" is displayed on the multi-information display in the combination meter assembly, inspect the No. 2 HV battery intake filter.

Click here
1. Detach the 2 claws.
2. Detach the 2 guides to remove the No. 2 HV battery intake filter.

*A	for Fixed Seat Type
*B	for Power Seat