HEIGHT CONTROL SENSOR(for Front Side)

Click here

CAUTION / NOTICE / HINT

Tip:

Use the same procedure for the RH and LH side.
The following procedure is for the LH side.

Click here

PROCEDURE

Click here
INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for 2WD)
1. Install the front height control sensor sub-assembly LH with the 2 bolts.
  
  8.5 N*m 87 kgf*cm 75 in.*lbf
  
  Note:
  Do not drop the front height control sensor sub-assembly LH. If it is dropped, replace it with a new one.
2. Install the front height control sensor link to the lower No. 2 suspension arm assembly LH with the bolt.
  
  5.4 N*m 55 kgf*cm 48 in.*lbf
3. Attach the clamp and connect the wire harness clamp.
4. Connect the connector.
5. Install the sensor clamp with the bolt.
  
  8.5 N*m 87 kgf*cm 75 in.*lbf
6. Connect the connector.
Click here
INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for AWD)
1. Install the front height control sensor sub-assembly LH with the 2 nuts.
  
  8.5 N*m 87 kgf*cm 75 in.*lbf
  
  Note:
  Do not drop the front height control sensor sub-assembly LH. If it is dropped, replace it with a new one.
2. Install the front height control sensor link to the lower No. 2 suspension arm assembly LH with the nut.
  
  5.4 N*m 55 kgf*cm 48 in.*lbf
3. Connect the connector.
Click here
INSTALL FRONT WHEEL LH

Click here
Click here
CHECK VEHICLE HEIGHT

Note:
If the height control sensor link is removed, check the vehicle height.
1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.
2. Measure the vehicle height.
  
  Click here
Click here
ADJUST VEHICLE HEIGHT

Click here

Note:
If the height control sensor has been replaced, be sure to adjust the vehicle height.
Click here
CHECK HEIGHT CHANGE OPERATION

Click here
Click here
ADJUST HEADLIGHT ASSEMBLY

Click here

HEIGHT CONTROL SENSOR(for Front Side) INSTALLATION