COOLER THERMISTOR INSTALLATION

PROCEDURE

1. Click here

   INSTALL HEIGHT CONTROL COMPRESSOR THERMISTOR ASSEMBLY

   
   
   1. 

      Attach the clamp to install the height control compressor thermistor assembly.

   2. Connect the connector.

2. Click here

   INSTALL W/O RELAY COMPRESSOR & DRYER ASSEMBLY

   Click here

3. Click here

   AIR CHARGING

   Click here

   Tip:
   

   • Make sure to use the nitrogen gas injector (SST) and adapter (SST).

   • Select an adapter (SST) that matches the standard of the nitrogen cylinder and install it.

   • The adapter (SST) is not required for JIS standard.

   09761-50010
   09761-05040	09761-05050	09761-05060	09761-05070

4. Click here

   CHECK CONNECTIONS OF TUBES FOR AIR LEAKAGE

   Click here

5. Click here

   CHECK VEHICLE HEIGHT

   Note:

   If the height control sensor link is removed, check the vehicle height.

   
   

   1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.

   2. Measure the vehicle height.

      Click here

6. Click here

   ADJUST VEHICLE HEIGHT

   Click here

   Note:

   If the height control sensor has been replaced, be sure to adjust the vehicle height.

7. Click here

   CHECK HEIGHT CHANGE OPERATION

   Click here