PNEUMATIC TANK INSTALLATION

PROCEDURE

1. Click here

   INSTALL NO. 5 HEIGHT CONTROL TUBE

   
   
   1. 

      Pass the No. 5 height control tube out from the trunk room to the outside of the vehicle.

   2. Pull the grommet through the lower side of the vehicle (exterior) and attach it.

   3. 

      Connect the No. 5 height control tube to the No. 3 height control valve assembly.

      Click here

      Note:

      Replace the O-ring, plate and No. 2 connector with new ones.

   4. 

      Connect the clamp.

2. Click here

   INSTALL HEIGHT CONTROL PRESSURE SENSOR

   
   
   1. 

      Apply a light coat of lithium soap base glycol grease to a new O-ring.

   2. Install the O-ring to the height control pressure sensor.

   3. Install the height control pressure sensor to the pneumatic tank with tube assembly.

      10.8 N*m

      110 kgf*cm

      8 ft.*lbf

3. Click here

   INSTALL PNEUMATIC TANK WITH TUBE ASSEMBLY

   
   
   1. 

      Install the pneumatic tank with tube assembly with the 3 bolts.

      19.1 N*m

      195 kgf*cm

      14 ft.*lbf

4. Click here

   CONNECT NO. 5 HEIGHT CONTROL TUBE

   
   
   1. 

      Connect the clamp.

   2. Connect the No. 5 height control tube to the pneumatic tank with tube assembly.

      Click here

      Note:

      Replace the O-ring, plate and No. 2 connector with new ones.

   3. Connect the harness clamp.

   4. Connect the connector.

5. Click here

   INSTALL BRAKE CONTROL POWER SUPPLY WITH BRACKET ASSEMBLY

   Click here

6. Click here

   INSTALL BATTERY CARRIER CATCH BRACKET SUB-ASSEMBLY

   Click here

7. Click here

   AIR CHARGING

   Click here

   Tip:
   

   • Make sure to use the nitrogen gas injector (SST) and adapter (SST).

   • Select an adapter (SST) that matches the standard of the nitrogen cylinder and install it.

   • The adapter (SST) is not required for JIS standard.

   09761-50010
   09761-05040	09761-05050	09761-05060	09761-05070

8. Click here

   CHECK CONNECTIONS OF TUBES FOR AIR LEAKAGE

   Click here

9. Click here

   INSTALL NO. 1 FLOOR UNDER COVER

   Click here

10. Click here

    CHECK VEHICLE HEIGHT

    Note:

    If the height control sensor link is removed, check the vehicle height.

    
    

    1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.

    2. Measure the vehicle height.

       Click here

11. Click here

    ADJUST VEHICLE HEIGHT

    Click here

    Note:

    If the height control sensor has been replaced, be sure to adjust the vehicle height.

12. Click here

    CHECK HEIGHT CHANGE OPERATION

    Click here