Click here

STEERING KNUCKLE(for AWD) REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering knuckle removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Suspension, tires, etc

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here

  • Parking assist ECU initialization

  • Adjust steering angle

  • Rear television camera view adjustment (for Rear camera detection system)

 Panoramic view monitor system

Click here
Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system

Click here

  • w/o Air Suspension System:

  • Replacement of the rear height control sensor sub-assembly LH, removal and reinstallation of the rear height control sensor sub-assembly LH, replacement of the suspension, etc. have been performed.

 Perform headlight ECU sub-assembly LH initialization Lighting system (EXT)

Click here
Note:

  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1341, C1342, C1343 and/or C1344 may be stored. As there is no malfunction, clear the DTCs.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

  • Be sure to read the "PRECAUTION" thoroughly before servicing.

    Click here

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

    Click here

  2. Click here

    REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (for AWD)

    Click here

  3. Click here

    REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY (for AWD)

    Click here

  4. Click here

    REMOVE STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY (for AWD)

    Click here

  5. Click here

    DISCONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here

  6. Click here

    REMOVE FRONT WHEEL

    Click here

  7. Click here

    DISCONNECT FRONT SPEED SENSOR

    Click here

  8. Click here

    DISCONNECT DISC BRAKE CYLINDER ASSEMBLY


  9. Click here

    REMOVE FRONT DISC LH


  10. Click here

    INSTALL FRONT AXLE SHAFT LH NUT

    Click here

  11. Click here

    REMOVE FRONT DISC BRAKE DUST COVER LH

    Click here

  12. Click here

    DISCONNECT TIE ROD ASSEMBLY LH

    Click here

  13. Click here

    LOOSEN FRONT SUSPENSION LOWER ARM ASSEMBLY LH


    1. B004XNA

      Loosen the 3 bolts.

  14. Click here

    DISCONNECT FRONT SUSPENSION UPPER ARM

    Click here

  15. Click here

    REMOVE STEERING KNUCKLE LH


    1. B004XNA

      Remve the 3 bolts and steering knuckle LH..

  16. Click here

    REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH

    Click here

  17. Click here

    REMOVE DISC BRAKE AIR GUIDE PLATE


    1. Remove the disc brake air guide plate from the steering knuckle LH.