Click here

SPARK PLUG REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil and spark plug removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Ignition coil assembly

  • Spark plug

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here
Click here

PROCEDURE


  1. Click here

    REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. Click here

    REMOVE RADIATOR COVER PLATE

    Click here

  3. Click here

    REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  4. Click here

    REMOVE LOWER RADIATOR AIR DEFLECTOR

    Click here

  5. Click here

    REMOVE RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH

    Click here

  6. Click here

    DISCONNECT NO. 2 PCV HOSE

    Click here

  7. Click here

    REMOVE AIR CLEANER WITH AIR CLEANER HOSE

    Click here

  8. Click here

    REMOVE IGNITION COIL ASSEMBLY

    Click here

  9. Click here

    REMOVE SPARK PLUG


    1. Remove the 6 spark plugs from the cylinder head sub-assembly.

      Note:

      If a spark plug has been struck or dropped, replace it.