FRONT DOOR OPENING TRIM WEATHERSTRIP REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front roof side rail weatherstrip LH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front Seat Assembly LH (Only for removal and installation)

  • Front Seat Assembly RH (Only for removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here

Tech Tips


  • Use the same procedure as for the LHD and RHD vehicles.

  • The procedure listed below is for the LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  3. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)

    Click here

  4. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  5. REMOVE FRONT DOOR OPENING TRIM COVER LH

    Click here

  6. REMOVE FRONT DOOR NO. 2 OPENING TRIM COVER LH

    Click here

  7. REMOVE FRONT PILLAR GARNISH LH

    Click here

  8. REMOVE REAR SEAT SIDE GARNISH

    Click here

  9. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  10. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  11. REMOVE REAR SEATBACK COVER

    Click here

  12. REMOVE REAR SEATBACK ASSEMBLY LH

    Click here

  13. REMOVE QUARTER INSIDE TRIM BOARD LH

    Click here

  14. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

    Click here

  15. REMOVE QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  16. REMOVE FRONT ROOF SIDE RAIL WEATHERSTRIP LH


    1. Detach the adhesional surface of the double-sided tape.

    2. Using a clip remover, detach the clips and remove the front roof side rail weatherstrip LH.

      B004CHJC01
      *a Double-sided Tape - -

    3. Clean the vehicle body.

      Tech Tips

      Remove any remaining sealer from the vehicle body.