HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure as for the LHD and RHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. REMOVE RADIATOR SUPPORT TO FRAME SEAL RH

    Click here

  2. REMOVE ENGINE ROOM SIDE COVER LH

    Click here

  3. REMOVE LOWER RADIATOR AIR DEFLECTOR

    Click here

  4. REMOVE FRONT FENDER REINFORCEMENT TOP SUB-ASSEMBLY LH (for LHD)

    Click here

  5. REMOVE FRONT FENDER REINFORCEMENT TOP SUB-ASSEMBLY RH (for RHD)

    Tech Tips

    Use the same procedure described for the LH side.

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  7. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. B004C03

      Detach the claws and remove the hood lock control lever sub-assembly.

    2. B004AUB

      Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.

  8. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR


    1. B004CL9

      Remove the 2 clips.

    2. Detach the clamp to remove the hood lock release lever protector.

  9. REMOVE HOOD LOCK CONTROL CABLE COVER LH (for LHD)


    1. B004BBS

      Detach the clamps and remove the hood lock control cable cover LH.

  10. REMOVE HOOD LOCK CONTROL CABLE COVER RH (for RHD)


    1. B004AF2

      Detach the clamps and remove the hood lock control cable cover RH.

  11. REMOVE HOOD LOCK ASSEMBLY


    1. B0049UU

      Disconnect the connector.

    2. Remove the 3 bolts and hood lock assembly.

    3. B004BT8

      for LHD:

      Disconnect the hood lock control cable assembly and hood lock control assembly to remove the hood lock assembly.

    4. B004A7E

      for RHD:

      Disconnect the hood lock control cable assembly and hood lock control assembly to remove the hood lock assembly.

  12. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


    1. B004BB4

      Tie a string to the end of the hood lock control cable assembly.

      Tech Tips

      Use a length of string long enough to pass through the engine compartment.

    2. for LHD:


      1. B004AX5C01
        *1 Hood Lock Control Cable Assembly
        *2 Wire Harness Grommet

        Pull out the hood lock control cable assembly through the wire harness grommet as shown in the illustration.

        Tech Tips

        Leave the string inside the grommet.

      2. Disconnect the string from the hood lock control cable assembly.

      3. B004C38C01
        *1 Hood Lock Control Cable Assembly
        *2 Grommet

        Using a screwdriver with its tip wrapped in protective tape, detach the clamps and remove the grommet and hood lock control cable assembly.

    3. for RHD:


      1. B004AN8C01
        *1 Hood Lock Control Cable Assembly
        *2 Wire Harness Grommet

        Pull out the hood lock control cable assembly through the wire harness grommet as shown in the illustration.

        Tech Tips

        Leave the string inside the grommet.

      2. Disconnect the string from the hood lock control cable assembly.

      3. B004AFOC02
        *1 Hood Lock Control Cable Assembly
        *2 Grommet

        Using a screwdriver with its tip wrapped in protective tape, detach the clamps and remove the grommet and hood lock control cable assembly.