TIRE PRESSURE WARNING RECEIVER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning receiver removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Tire pressure warning ECU and receiver

  • Register transmitter ID

  • Initialize tire pressure warning system

  • When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

  • Tire pressure warning function

for Initialization: Click here

for Registration: Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE NO. 2 DECK BOARD

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  5. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  6. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  7. REMOVE REAR SEAT SIDE GARNISH

    Click here

  8. REMOVE REAR SEATBACK COVER

    Click here

  9. REMOVE REAR SEATBACK ASSEMBLY RH

    Click here

  10. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  11. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  12. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY RH

    Click here

  13. REMOVE QUARTER INSIDE TRIM BOARD RH

    Click here

  14. REMOVE REAR INNER SEAT BELT ASSEMBLY RH

    Click here

  15. REMOVE QUARTER TRIM PANEL ASSEMBLY RH

    Click here

  16. REMOVE INNER ROOF SIDE GARNISH RH

    Click here

  17. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

    Note


    • Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.

    • If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.


    1. B004B1J

      Remove the bolt.

    2. Detach the 2 guides and tire pressure warning ECU and receiver.

    3. Disconnect the connector.