DIGITAL AUDIO BROADCASTING ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the digital audio broadcasting antenna removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front Seat Assembly RH (Only for removal and installation)

  • Front Seat Assembly LH (Only for removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B004CGW

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE NO. 2 DECK BOARD

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    CAUTION:

    B004A52

    • Wait at least 90 seconds after disconnecting the cable from the negative(-) auxiliary battery terminal to disable the SRS system.

      Click here

    • If the airbag deploys for any reason, it may cause a serious accident.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE FRONT SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  5. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  6. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  7. REMOVE REAR SEAT SIDE GARNISH

    Click here

  8. REMOVE REAR SEATBACK COVER

    Click here

  9. REMOVE REAR SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  10. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  11. REMOVE QUARTER INSIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  12. REMOVE REAR SEAT INNER BELT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  13. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  14. REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR)

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  15. REMOVE QUARTER TRIM PANEL ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  16. REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY


    1. Disconnect the 2 connectors and remove the No. 5 antenna cord assembly.

      B004ATW