CAN COMMUNICATION SYSTEM, Diagnostic DTC:U0134

DTC Code DTC Name
U0134 Lost Communication with DRS Module

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U0134 Lost Communication with DRS Module Communication stop occurs between the rear steering control ECU and ECU or sensor outputs DTC(s)

  • Rear steering control ECU

  • Rear steering control ECU CAN branch wire or connector

  • Rack and pinion power steering gear assembly

  • Skid control ECU assembly

  • Front steering control ECU (w/ Variable Gear Ratio Steering System)

WIRING DIAGRAM

B000WH1E10
*1 No. 18 CAN Junction Connector
*2 Rear Steering Control ECU

CAUTION / NOTICE / HINT

CAUTION:

When performing the confirmation driving pattern, obey all speed limits and traffic laws.

Note


  • Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

    Click here

  • Before measuring the resistance of the CAN bus, turn the engine switch off and leave the vehicle for 1 minute or more without operating the key or any switches, or opening or closing the doors. After that, disconnect the cable from the negative (-) battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.

  • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  • Some parts must be initialized and set when replacing or removing and installing parts.

    Click here

  • After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.

    DTC check procedure: Turn the engine switch on (IG) and wait for 1 minute or more. Then operate the suspected malfunctioning system and drive the vehicle at 60 km/h (37 mph) or more for 5 minutes or more.

  • After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed as normal.

    Click here

Tech Tips


  • Before disconnecting related connectors for inspection, push in on each connector body to check that the connector is not loose or disconnected.

  • When a connector is disconnected, check that the terminals and connector body are not cracked, deformed or corroded.

PROCEDURE


  1. CHECK FOR OPEN IN CAN BUS WIRE (REAR STEERING CONTROL ECU BRANCH WIRE)


    1. Disconnect the cable from the negative (-) battery terminal.

    2. B000X16C09
      *a

      Front view of wire harness connector

      (to Rear Steering Control ECU)

      Disconnect the rear steering control ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      b3-6 (CN2+) - b3-7 (CN2-) Cable disconnected from negative (-) battery terminal 54 to 69 Ω
      Result
      Result
      OK
      NG

    OK

    REPLACE REAR STEERING CONTROL ECU Click here

    NG

    REPAIR OR REPLACE CAN BRANCH WIRE OR CONNECTOR