LUGGAGE COMPARTMENT DOOR ADJUSTMENT

PROCEDURE

1. Click here

   INSPECT LUGGAGE COMPARTMENT DOOR

   
   
   1. 

      Check that the clearance measurements of areas a through d are within each standard range.

      Table 1. Standard Clearance

      Area	Measurement	Area	Measurement
      a	5.8 mm (0.228 in.)	b	2.6 to 5.6 mm (0.102 to 0.220 in.)
      c	-1.4 to 1.6 mm (-0.0551 to 0.063 in.)	d	4.0 to 8.0 mm (0.157 to 0.315 in.)

2. Click here

   REMOVE SPARE WHEEL COVER ASSEMBLY

   Click here

3. Click here

   REMOVE SPARE WHEEL COVER TRAY

   Click here

4. Click here

   REMOVE REAR FLOOR FINISH PLATE

   Click here

5. Click here

   REMOVE LUGGAGE COMPARTMENT DOOR COVER

   Click here

6. Click here

   REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH

   Click here

7. Click here

   REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH

   Click here

8. Click here

   ADJUST LUGGAGE COMPARTMENT DOOR

   
   
   1. 

      Loosen the 4 door side hinge bolts to adjust the door horizontally and vertically.

   2. Tighten the 4 bolts after adjustment.

      7.5 N*m

      76 kgf*cm

      66 in.*lbf

   3. 

      Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.

   4. Using a brass bar and a hammer, hit the striker to adjust its position.

   5. Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.

      23 N*m

      235 kgf*cm

      17 ft.*lbf

9. Click here

   INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER LH

   Click here

10. Click here

    INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER RH

    Click here

11. Click here

    INSTALL LUGGAGE COMPARTMENT DOOR COVER

    Click here

12. Click here

    INSTALL REAR FLOOR FINISH PLATE

    Click here

13. Click here

    INSTALL SPARE WHEEL COVER TRAY

    Click here

14. Click here

    INSTALL SPARE WHEEL COVER ASSEMBLY

    Click here