FRONT DOOR BELT MOULDING INSTALLATION
CAUTION / NOTICE / HINT
Tech Tips
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
PROCEDURE
-
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
-
INSTALL FRONT DOOR BELT MOULDING ASSEMBLY
-
Engage the 7 claws to install the front door belt moulding assembly.
-
-
CONNECT FRONT DOOR WEATHERSTRIP
-
Engage the 2 clips to connect the front door weatherstrip.
-
-
INSTALL FRONT DOOR FRONT LOWER FRAME UPPER COVER
-
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
-
INSTALL FRONT DOOR UPPER WINDOW STOP
-
INSPECT FRONT DOOR GLASS SUB-ASSEMBLY
-
ADJUST FRONT DOOR GLASS SUB-ASSEMBLY
-
INSTALL FRONT DOOR SERVICE HOLE COVER
-
INSTALL OUTER MIRROR INSTALL HOLE COVER
-
INSTALL FRONT DOOR TRIM BRACKET
-
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
-
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
-
INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION
-
INSTALL COURTESY LIGHT ASSEMBLY
-
INSTALL DOOR TRIM COVER
-
INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
-
INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
-
INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
-
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
-
INSTALL BATTERY SERVICE HOLE COVER LH
-
INITIALIZE POWER WINDOW CONTROL SYSTEM
-
INSPECT POWER WINDOW OPERATION