NETWORK GATEWAY ECU REMOVAL

CAUTION / NOTICE / HINT

Note


  • When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.

  • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  2. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

    Click here

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for RHD)

    Click here

  4. REMOVE FRONT NO. 2 CONSOLE BOX INSERT (for LHD)

    Click here

  5. REMOVE FRONT NO. 1 CONSOLE BOX INSERT (for RHD)

    Click here

  6. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  8. REMOVE NETWORK GATEWAY ECU


    1. B004G4R

      Disconnect the network gateway ECU connector.

    2. Remove the 2 bolts and network gateway ECU from the blower assembly.