NAVIGATION ECU REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:


      • A communication malfunction DTC may be stored.

      • The radio receiver assembly or navigation ECU may not operate normally.

    • After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio receiver assembly.

  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  5. REMOVE FRONT PANEL GARNISH LH

    Click here

  6. REMOVE FRONT PANEL GARNISH RH

    Click here

  7. REMOVE CONSOLE PANEL SUB-ASSEMBLY

    Click here

  8. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

    Click here

  9. REMOVE NO. 1 NAVIGATION WIRE


    1. B004EL4

      Disconnect the 2 connectors to remove the No. 1 navigation wire.

  10. REMOVE NO. 1 RADIO BRACKET

    Click here

  11. REMOVE NO. 2 RADIO BRACKET

    Click here

  12. REMOVE RADIO RECEIVER ASSEMBLY

  13. REMOVE NAVIGATION ECU