RADIO ANTENNA CORD REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  5. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

    Click here

  6. REMOVE NO. 1 CONSOLE BOX DUCT

    Click here

  7. REMOVE ANTENNA CORD SUB-ASSEMBLY


    1. B004FDA

      Disconnect each connector.

    2. Disengage each clamp and remove the antenna cord sub-assembly.

  8. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  9. REMOVE FRONT SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  10. REMOVE REAR SEAT ASSEMBLY

    Click here

  11. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  13. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side.

  14. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  15. REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT

    Click here

  16. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  17. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER

    Click here

  18. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

    Click here

  19. REMOVE REAR SEAT SUB FLOOR PANEL

    Click here

  20. REMOVE NO. 1 ROOM PARTITION COVER

    Tech Tips

    Use the same procedure as for the No. 2 room partition cover.

    Click here

  21. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY


    1. B004G1V

      Remove the 4 clips.

    2. B004GA8

      Disengage the 2 guides.

    3. Turn back the floor carpet as shown in the illustration so that the No. 2 antenna cord sub-assembly can be removed.

    4. Disconnect each connector.

      A01WXSQ

    5. Remove the 2 bolts.

    6. Disengage each clamp and remove the No. 2 antenna cord sub-assembly.

  22. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

    Click here

  23. REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY


    1. B004G3Q

      Disconnect the 2 connectors.

    2. Disengage each clamp and remove the No. 5 antenna cord sub-assembly.