RADIO RECEIVER REMOVAL

PROCEDURE

1. PRECAUTION

   
   

   1. w/o Navigation System:

      Note

      
      

      • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:

      
      

      • A communication malfunction DTC may be stored.

      • The radio receiver assembly may not operate normally.

   2. w/ Navigation System:

      Note

      
      

      • When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

      
      

      • A communication malfunction DTC may be stored.

      • The radio receiver assembly or navigation ECU may not operate normally.

      • After replacing the radio receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.

2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

   Click here

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

   Click here

5. REMOVE FRONT PANEL GARNISH LH

   Click here

6. REMOVE FRONT PANEL GARNISH RH

   Click here

7. REMOVE CONSOLE PANEL SUB-ASSEMBLY

   Click here

8. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

   
   

   1. 

      Remove the 4 bolts.

   2. Pull the radio receiver assembly with bracket toward the rear of the vehicle and disengage the 4 clips.

   3. Disconnect each connector and remove the radio receiver assembly with bracket.

9. REMOVE NO. 1 NAVIGATION WIRE (w/ Navigation System)

   Click here

10. REMOVE NO. 1 RADIO BRACKET

    
    

    1. w/o Navigation System:

       
       

       1. 

          Remove the 3 screws and No. 1 radio bracket.

    2. w/ Navigation System:

       
       

       1. 

          Remove the 5 screws and No. 1 radio bracket.

11. REMOVE NO. 2 RADIO BRACKET

    
    

    1. w/o Navigation System:

       
       

       1. 

          Remove the 3 screws and No. 2 radio bracket.

    2. w/ Navigation System:

       
       

       1. 

          Remove the 5 screws and No. 2 radio bracket.

12. REMOVE NAVIGATION ECU (w/ Navigation System)

13. REMOVE RADIO RECEIVER ASSEMBLY