REAR DISC BRAKE PAD REPLACEMENT

CAUTION / NOTICE / HINT

Note


  • After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.

  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1341, C1342, C1343 and/or C1344 may be stored. As there is no malfunction, clear the DTCs.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake pads are to be removed and installed, be sure to remove the ABS motor relays before beginning work.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE ABS MOTOR RELAY

    for LHD: Click here

    for RHD: Click here

  2. REMOVE REAR WHEEL

    Click here

  3. REMOVE REAR DISC BRAKE PAD


    1. B004FP3C01
      *a Turn
      *b Hold

      Hold the rear No. 2 disc brake cylinder slide pin and remove the bolt.

    2. Pull the rear disc brake cylinder assembly upward.

    3. B004F58

      Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

      CAUTION:

      Be careful not to get pinched by the rear disc brake cylinder assembly or other parts when removing the rear disc brake pads.

  4. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

    Click here

  5. INSTALL REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

    Click here

  6. INSTALL REAR DISC BRAKE PAD


    1. B004F8QN01

      Using SST, push in the rear disc brake piston.

      SST
      09719-77020

      Note


      • Make sure the brake fluid does not overflow from the reservoir.

      • Do not forcibly push in the rear disc brake piston.

    2. Install the 2 rear disc brake pads to the rear disc brake cylinder mounting.

      CAUTION:

      Be careful not to get pinched by the rear disc brake cylinder assembly or other parts when installing the rear disc brake pads.

      Note

      There should be no oil or grease on the friction surfaces of the disc brake pads or the rear disc.

    3. Hold the rear No. 2 disc brake cylinder slide pin and install the rear disc brake cylinder assembly to the rear disc brake cylinder mounting with the bolt.

      Torque:
      26.5 N*m  { 270 kgf*cm, 20 ft.*lbf }

  7. INSTALL ABS MOTOR RELAY


    1. With the power switch off, install the 2 ABS motor relays (ABS motor No. 1 relay and ABS motor No. 2 relay).

    2. Clear the DTCs.

      Click here

  8. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

    Click here

  9. INSTALL REAR WHEEL

    Click here