REAR ACCELERATION SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER

    Click here

  5. REMOVE LUGGAGE COMPARTMENT TRIM BOX

    Click here

  6. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER

    Click here

  7. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

    Click here

  8. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  9. REMOVE FRONT UPPER LUGGAGE COMPARTMENT TRIM COVER

    Click here

  10. SEPARATE LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  11. REMOVE ACCELERATION SENSOR ASSEMBLY


    1. Turn back the luggage compartment trim cover RH until the acceleration sensor assembly can be seen.

    2. B004GLR

      Disconnect the connector.

    3. Remove the bolt and acceleration sensor assembly.

      Note


      • Avoid any impact to the acceleration sensor assembly.

      • Do not drop the acceleration sensor assembly. If it is dropped, replace it with a new one.