FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  5. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  6. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  7. REMOVE LAP BELT OUTER ANCHOR COVER


    1. B004GU7

      Disengage the 2 claws.

    2. Disengage the guide to remove the lap belt outer anchor cover.

  8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

    B004FVL

    1. Remove the nut and disconnect the floor anchor of the front seat outer belt assembly.

  9. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

    Click here

  10. REMOVE REAR SIDE SEATBACK ASSEMBLY

    Click here

  11. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

    Click here

  12. REMOVE CENTER PILLAR GARNISH ASSEMBLY

    Click here

  13. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

    B004FV6

    1. Remove the bolt and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. B004GOYC01
      *a Protective Tape
      *b Locking Button
      *c Release

      Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Disconnect the connector.

    4. B004FSH

      Remove the 2 bolts and front seat outer belt assembly.

  14. REMOVE OUTER BELT ANCHOR BRACKET SUB-ASSEMBLY


    1. B004E1T

      Remove the clip.

    2. Disengage the guide.

    3. Turn back the floor carpet as shown in the illustration.

    4. B004EGP

      Remove the bolt.

    5. Disengage the clip to remove the outer belt anchor bracket sub-assembly.