REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing.

   Click here

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

   Click here

2. REMOVE BATTERY SERVICE HOLE COVER LH

   Click here

3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. REMOVE REAR SEAT CUSHION ASSEMBLY

   Click here

5. REMOVE REAR SEAT CUSHION LOCK HOOK

   Click here

6. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

   Click here

7. REMOVE REAR SIDE SEATBACK ASSEMBLY

   Click here

8. REMOVE FRONT DOOR SCUFF PLATE

   Click here

9. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

   Click here

10. REMOVE REAR AIRBAG SENSOR

    
    

    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

       CAUTION:

       Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Disconnect the connector from the rear airbag sensor.

       Note

       When disconnecting any airbag connector, take care not to damage the airbag wire harness.

       
       

       1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

          

          *a	White Housing Lock	*b	Yellow CPA
          *c	Slide	*d	Push

       2. Push down the white housing lock again and disconnect the connector.

          Note

          Do not push down the part (A) shown in the illustration when disconnecting the connector.

    4. 

       Remove the bolt and rear airbag sensor from the vehicle body.

       Note

       Loosen the bolt while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

    5. After disconnecting the connector, check that the position of the white housing lock is as shown in the illustration.

       

       *a

       Correct

       *b

       Incorrect