ROOF DRIP SIDE FINISH MOULDING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during roof drip side finish moulding removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Intelligent clearance sonar system*1
Pre-crash safety system

Lighting system (EXT)


  • Cornering lights
Adaptive high beam system
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking assist monitor system (w/ Parallel parking assist function)

Click here

Parking assist monitor system (w/o Parallel parking assist function)

Click here

Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

B005NS4

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING (w/o Roof Rack)


    1. Apply protective tape around the center roof drip side finish moulding.

      B005N1PC02
      B005M97 Protective Tape - -

    2. Using a moulding remover, disengage the 2 clips and remove the center roof drip side finish moulding.

      B005OWH

  2. REMOVE ROOF RACK ASSEMBLY (w/ Roof Rack)

    Click here

  3. REMOVE ROOF DRIP SIDE MOULDING (w/ Roof Rack)


    1. except Panoramic Moon Roof:


      1. B005QDXC01
        B005M97 Protective Tape

        Apply protective tape around the roof drip side moulding.

      2. B005LN5

        Using a moulding remover, disengage the clip and remove the roof drip side moulding.

  4. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING (w/ Roof Rack)


    1. B005LO1C01
      B005M97 Protective Tape

      Apply protective tape around the rear roof drip side finish moulding.

    2. B005PXW

      Using a moulding remover, disengage the clip and remove the rear roof drip side finish moulding.