FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front door belt moulding removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative (-) battery terminal	Memorize steering angle neutral point	LKA/LDA System	Click here
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking assist monitor system (w/ Parallel parking assist function)	Click here
		Parking assist monitor system (w/o Parallel parking assist function)	Click here
		Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here
Door glass Door glass run	Initialize Power Window Control System	Auto up and down function Jam protection function Remote control function Key-linked function Wireless transmitter-linked function Key-off operation function Catch protection function Window open warning function	Click here

Tech Tips

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

Click here
REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Click here
REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Click here
REMOVE DOOR ARMREST COVER

Click here
REMOVE COURTESY LIGHT ASSEMBLY

Click here
REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

Click here
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Click here
REMOVE FRONT DOOR NO. 1 TRIM BRACKET

Click here
REMOVE FRONT DOOR SERVICE HOLE COVER

Click here
REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Click here
REMOVE FRONT DOOR GLASS RUN

Click here
REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY

Click here
REMOVE FRONT DOOR FIX WINDOW GLASS

Click here
REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
1. Protective Tape
  
  Apply protective tape around the front door belt moulding assembly.
2. Remove in this Direction
  
  Disengage the 8 claws as shown in the illustration to remove the front door belt moulding assembly.