CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hazard warning switch removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | LKA/LDA System | |
| Intelligent clearance sonar system*1 | |||
| Pre-crash safety system | |||
| Lighting system (EXT)
|
|||
| Adaptive high beam system | |||
| Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) | Stop and start system | ||
| Memorize steering angle neutral point | Parking assist monitor system (w/ Parallel parking assist function) | ||
| Parking assist monitor system (w/o Parallel parking assist function) | |||
| Panoramic view monitor system | |||
| Initialize back door lock | Power door lock control system | ||
| Reset back door close position | Power back door system | ||
| Replacement of radio receiver assembly (w/ Parallel Parking Assist Function) | Parking assist monitor system initialization | Parking assist monitor system (w/ Parallel parking assist function) | Click here for Initialization Click here for Calibration |
| Replacement of radio receiver assembly (w/ G-BOOK) | Vehicle contract setting |
|
Click here for Initialization*2 Click here for Initialization*3 |
| Download necessary data | Some G-BOOK service content will be unavailable. | Click here for Registration*2 Click here for Registration*3 |
*1: When performing learning using the GTS.
*2: w/ Telematics Transceiver
*3: w/o Telematics Transceiver
PROCEDURE
REMOVE HAZARD WARNING SWITCH (RADIO RECEIVER ASSEMBLY) (w/o Navigation System)
REMOVE HAZARD WARNING SWITCH (RADIO RECEIVER ASSEMBLY) (w/ Navigation System)