HEIGHT CONTROL SENSOR INSTALLATION

PROCEDURE

1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

   
   

   1. 

      Temporarily install the rear height control sensor sub-assembly RH with the 2 nuts.

      Torque:

      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

   2. Engage the guide.

   3. Connect the rear height control sensor sub-assembly RH with the bolt.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

   4. 

      Engage the guide.

   5. Install the rear height control sensor sub-assembly RH with the bolt.

      Note

      If the rear height control sensor sub-assembly RH has been struck or dropped, replace it with a new one.

      Torque:

      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

   6. Connect the connector.

2. INSTALL REAR WHEEL (for RH Side)

   Click here

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. PERFORM INITIALIZATION

   Click here

5. INSPECT HEADLIGHT AIMING

   for Triple Beam Headlight:

   Click here

   for Single Beam Headlight:

   Click here