REAR NO. 1 SEAT INNER BELT ASSEMBLY(for 60/40 Split Seat Type LH Side) REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear No. 1 seat inner belt assembly removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | LKA/LDA System | |
| Intelligent Clearance Sonar System*1 | |||
| Pre-crash Safety System | |||
| Lighting System (EXT)
|
|||
| Adaptive High Beam System | |||
| Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) | Stop and Start System | ||
| Memorize steering angle neutral point | Parking Assist Monitor System (w/ Parallel Parking Assist Function) | ||
| Parking Assist Monitor System (w/o Parallel Parking Assist Function) | |||
| Panoramic View Monitor System | |||
| Initialize back door lock | Power Door Lock Control System | ||
| Reset back door close position | Power Back Door System |
*1: When performing learning using the GTS.
CAUTION:
-
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
-
Wear protective gloves. Sharp areas on the seat frame may injure your hands.
PROCEDURE
-
REMOVE REAR NO. 1 SEAT ASSEMBLY LH
-
REMOVE REAR SEAT COVER CAP LH
-
REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH
-
REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
-
REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
-
REMOVE REAR NO. 1 SEAT RECLINING ADJUSTER INSIDE COVER
-
REMOVE REAR SEAT INNER BELT ASSEMBLY LH
-
w/ Seat Belt Warning System:
-
Disconnect the connector.
-
Disengage 2 clamps.
-
-
Remove the bolt and rear seat inner belt assembly LH.
-