FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. B005LNJE01

      Engage the guide and temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.

    2. Fully tighten the bolt (A), and then the bolt (B) to install the front shoulder belt anchor adjuster assembly.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

  3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. B005M2LC01

      Engage the 2 guides and temporarily install the front seat outer belt assembly with the 2 bolts.

    2. Fully tighten the bolt (A), and then the bolt (B) to install the front seat outer belt assembly.

      Torque:
      Bolt (A)
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }
      Bolt (B)
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    3. B005QAJC01
      *a Locking Button
      *b Lock

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note

      Securely lock the locking button.

    4. Connect the connector.

    5. Connect the shoulder anchor of the front seat outer belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    6. Check that the ELR locks.

      Note

      This check should be performed with the front seat outer belt assembly installed to the vehicle.


      1. With the front seat outer belt assembly installed to the vehicle, check that the belt locks when it is pulled out quickly.

  4. INSTALL CENTER PILLAR GARNISH

    Click here

  5. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. B005MDC

      Connect the floor anchor of the front seat outer belt assembly with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  6. INSTALL LOWER CENTER PILLAR GARNISH

    Click here

  7. INSTALL REAR DOOR SCUFF PLATE (w/o Rear No. 2 Seat)

    Click here

  8. INSTALL REAR DOOR INSIDE SCUFF PLATE (w/ Rear No. 2 Seat)

    Click here

  9. INSTALL REAR DOOR SCUFF PLATE (w/ Rear No. 2 Seat)

    Click here

  10. INSTALL FRONT DOOR SCUFF PLATE

    Click here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  12. INSPECT SRS WARNING LIGHT

    Click here