FRONT SEAT INNER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	LKA/LDA System	Click here
		Pre-Crash Safety System
		Lighting System (EXT) Cornering lights
		Adaptive High Beam System
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking Assist Monitor System (w/ Parallel Parking Assist Function)	Click here
		Parking Assist Monitor System (w/o Parallel Parking Assist Function)	Click here
		Panoramic View Monitor System	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here
Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY

Click here
REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
1. Disconnect each connector under the front seat assembly.
2. Disengage each clamp under the front seat assembly.
3. Disengage the clamp.
4. Remove the nut and front seat inner belt assembly.
5. Remove in this Direction
  
  Remove the front seat belt anchor plate as shown in the illustration.
REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
1. Disconnect each connector under the front seat assembly.
2. Disengage each clamp under the front seat assembly.
3. Disengage the clamp.
4. Remove the nut and front seat inner belt assembly.
5. Remove in this Direction
  
  Remove the front seat belt anchor plate as shown in the illustration.