REAR SEAT CUSHION HEATER(for 60/40 Split Seat Type LH Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat cushion heater removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Pre-Crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

CAUTION:


  • B005NS4

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the seat frame may injure your hands.

PROCEDURE


  1. REMOVE REAR SEAT ASSEMBLY LH

    Click here

  2. REMOVE REAR CENTER SEAT INNER BELT ASSEMBLY

    Click here

  3. REMOVE REAR SEAT COVER CAP LH (for Manual Seat)

    Click here

  4. REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)

    Click here

  5. REMOVE POWER SEAT SWITCH ASSEMBLY (for Power Seat)

    Click here

  6. DISCONNECT SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD

    Click here

  7. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD

    Click here

  8. REMOVE REAR SEAT CUSHION HEATER (SEPARATE TYPE REAR SEAT CUSHION COVER)


    1. B005MPBC01
      B005M97 Fastener

      Disengage the fastener.

    2. B005O2B

      Remove the 6 hog rings.

    3. B005OHV

      Remove the 20 hog rings and rear seat cushion heater (separate type rear seat cushion cover) from the separate type rear seat cushion pad.