FRONT SEATBACK HEATER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seatback heater removal/installation are shown below.

Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	LKA /LDA system	Click here
		Intelligent clearance sonar system*1
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
		Parking Assist Monitor System (w/ Parallel Parking Assist Function)	Click here
		Parking Assist Monitor System (w/o Parallel Parking Assist Function)	Click here
		Panoramic view monitor system	Click here
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here
w/ occupant classification system Front passenger seat	Zero point calibration (Occupant classification system)	Occupant classification system Passenger airbag ON/OFF indicator Airbag system (Front passenger side) Seat belt warning system (Front passenger)	Click here
Front seatback frame sub-assembly (driver seat) Front seat adjuster assembly (driver seat) Front seatback frame sub-assembly (front passenger seat) Front seat adjuster assembly (front passenger seat)	Initialize position control ECU	Front Power Seat Control System (w/ Memory)	Click here

*1: When performing learning using the GTS.
Click here Click here

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here
Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY

Click here
DISCONNECT FRONT SEATBACK BOARD SUB-ASSEMBLY

Click here
REMOVE FRONT SEAT CUSHION SHIELD (for Standard Seat Type)

Click here
REMOVE INNER NO. 1 FRONT SEAT CUSHION SHIELD (for Standard Seat Type)

Click here
REMOVE INNER NO. 1 FRONT SEAT CUSHION SHIELD (for Sports Seat Type)

Click here
REMOVE FRONT SEAT CUSHION SHIELD (for Sports Seat Type)

Click here
REMOVE FRONT SEAT INNER CUSHION SHIELD

Click here
REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Click here
REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY

Click here
REMOVE FRONT SEAT HEADREST SUPPORT

Click here
REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Standard Seat Type)

Click here
REMOVE FRONT SEATBACK HEATER (SEPARATE TYPE FRONT SEATBACK COVER) (for Standard Seat Type)
Tech Tips

The front seatback heater cannot be removed from the separate type front seatback cover as they are a unit.
1. Remove the 12 hog rings and front seatback heater (separate type front seatback cover) from the separate type front seatback pad.
REMOVE FRONT SEATBACK HEATER (FRONT SEATBACK PAD WITH COVER) (for Sports Seat Type)

Tech Tips

The front seatback heater cannot be removed from the front seatback pad with cover as they are a unit.
1. *a Bracket
  
  Remove the 2 nuts and disengage the 2 brackets.
2. Remove the front seatback heater (front seatback pad with cover).