REAR NO. 2 SEAT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the seat frame may injure your hands.

PROCEDURE


  1. INSTALL REAR NO. 2 SEAT ASSEMBLY


    1. Place the rear No. 2 seat assembly in the cabin.

      Note

      Be careful not to damage the rear No. 2 seat assembly, vehicle body or vehicle interior.

    2. Engage the 2 pins to temporarily install the rear No. 2 seat assembly.

    3. Temporarily install the 3 bolts on the front side of the rear No. 2 seat assembly.

    4. Temporarily install the 5 bolts on the rear side of the rear No. 2 seat assembly.

    5. B005PMNN02

      Tighten the 5 bolts on the rear side of the rear No. 2 seat assembly.

      Tech Tips

      Tighten the bolts in the order shown in the illustration.

      Torque:
      36.7 N*m  { 374 kgf*cm, 27 ft.*lbf }
    6. B005OJUN01

      Tighten the 3 bolts on the front side of the rear No. 2 seat assembly to install it.

      Tech Tips

      Tighten the bolts in the order shown in the illustration.

      Torque:
      36.7 N*m  { 374 kgf*cm, 27 ft.*lbf }

    7. Engage the 6 clips.

    8. Connect the 2 connectors.

  2. INSTALL FRONT DECK FLOOR BOX

    Click here

  3. INSTALL NO. 2 DECK FLOOR BRACKET LH (w/ Woofer)


    1. Install the No. 2 deck floor bracket LH with the 2 nuts.

  4. INSTALL REAR NO. 3 SPEAKER ASSEMBLY (w/ Woofer)

    Click here

  5. INSTALL REAR FLOOR FINISH PLATE

    Click here

  6. INSTALL REAR DECK FLOOR BOX

    Click here

  7. CONNECT REAR NO. 2 SEAT ASSEMBLY

    Click here

  8. INSTALL NO. 1 DECK BOARD

    Click here

  9. INSTALL DECK SIDE TRIM BOX LH

    Click here

  10. INSTALL REAR NO. 4 FLOOR BOARD

    Click here

  11. INSTALL DECK BOARD ASSEMBLY

    Click here

  12. INSTALL TONNEAU COVER ASSEMBLY

    Click here

  13. PERFORM INITIALIZATION

    Note

    It is necessary to perform Initialization (initial position memorization) in the following situations.


    • The fold seat control ECU has been replaced with a new one.

    • Initialization Cancel (Initial Position Reset) has been performed.

    • The cable was disconnected from the negative (-) battery terminal when a rear power seat was being operated.

    Click here