OCCUPANT CLASSIFICATION ECU INSTALLATION

PROCEDURE

1. INSTALL OCCUPANT DETECTION ECU

   
   

   1. 

      Engage the claw to install the occupant detection ECU.

      Note

      If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.

   2. Connect the 2 connectors.

      Note

      When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

2. INSTALL FRONT SEAT ASSEMBLY RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

3. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

4. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK

   Click here