SIDE AIRBAG SENSOR(for Center Pillar) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      B005NWT

    3. Before connecting the connector, check that the position of the white housing lock is as shown in the illustration.

      B005OA1C01
      *a Correct *b Incorrect

    4. Engage the claw and install the side airbag sensor assembly with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the side airbag sensor assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the side airbag sensor assembly claw is securely inserted into the body hole.

    5. Connect the connector to the side airbag sensor assembly.

      B005PKXC15
      *a White Housing Lock *b Connect

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      Tech Tips


      • Be sure to connect the connector until it is locked (when locking, make sure that a click sound can be heard).

      • When the connector is locked, the white housing lock will slide. Do not hold the white housing lock or the part (A) as it may result in an insecure connection.

    6. Check that there is no looseness in the installed parts of the side airbag sensor assembly.

  2. INSTALL LOWER CENTER PILLAR GARNISH

    w/o Rear No. 2 Seat: Click here

    w/ Rear No. 2 Seat: Click here

  3. INSTALL REAR DOOR INSIDE SCUFF PLATE (w/ Rear No. 2 Seat)

    Click here

  4. INSTALL REAR DOOR SCUFF PLATE

    w/o Rear No. 2 Seat: Click here

    w/ Rear No. 2 Seat: Click here

  5. INSTALL FRONT DOOR SCUFF PLATE

    w/o Rear No. 2 Seat: Click here

    w/ Rear No. 2 Seat: Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. INSPECT SRS WARNING LIGHT

    Click here