CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
Note
The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
Tech Tips
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY
INSTALL REAR DOOR GLASS SUB-ASSEMBLY
INSTALL REAR DOOR REAR GUIDE SEAL
INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
INSTALL REAR DOOR GLASS RUN
CONNECT REAR DOOR WEATHERSTRIP
INSTALL REAR DOOR SERVICE HOLE COVER
INSTALL REAR DOOR NO. 2 TRIM BRACKET
INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
INSTALL COURTESY LIGHT ASSEMBLY
INSTALL REAR DOOR ARMREST COVER
INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
INITIALIZE POWER WINDOW CONTROL SYSTEM
INSPECT POWER WINDOW OPERATION