POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during power window regulator motor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Pre-Crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here


  • Door window regulator assembly

  • Power window regulator motor assembly

  • Door glass

  • Door glass run

 Initialize Power Window Control System

  • Auto up and down function

  • Jam protection function

  • Remote control function

  • Key-linked function

  • Wireless transmitter-linked function

  • Key-off operation function

  • Catch protection function

  • Window open warning function

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

  5. REMOVE REAR DOOR ARMREST COVER

    Click here

  6. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  9. REMOVE REAR DOOR NO. 2 TRIM BRACKET

    Click here

  10. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  11. DISCONNECT REAR DOOR WEATHERSTRIP

    Click here

  12. REMOVE REAR DOOR GLASS RUN

    Click here

  13. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

    Click here

  14. REMOVE REAR DOOR REAR GUIDE SEAL

    Click here

  15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  16. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY

    Click here

  17. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. B005O4J

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.