POWER OUTLET SOCKET REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during power outlet socket removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Intelligent clearance sonar system*1
Pre-Crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

    Click here

  2. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  3. REMOVE CIGAR LIGHTER HOLE COVER


    1. Remove the cigar lighter hole cover.

  4. REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY


    1. B005P5ZC01
      *a Protective Tape
      B005OOA Remove in this Direction

      Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the No. 1 power outlet socket assembly as shown in the illustration.

  5. REMOVE POWER OUTLET SOCKET LENS


    1. B005NZYC01
      B005OOA Remove in this Direction

      Disengage the 2 claws and remove the power outlet socket lens as shown in the illustration.