AIR CONDITIONING AMPLIFIER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air conditioning amplifier removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	LKA/LDA System	Click here
		Intelligent clearance sonar system*2
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking assist monitor system (w/ Parallel parking assist function)	Click here
		Parking assist monitor system (w/ Parallel parking assist function)	Click here
		Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here
Removal/installation of the spiral cable with sensor sub-assembly	Steering angle neutral point (Initialize parking assist monitor system) Steering angle setting	Parking assist monitor system (w/ Parallel parking assist function)	Click here for Initialization Click here for Calibration
		Parking assist monitor system (w/o parallel parking assist function)	Click here for Initialization Click here for Calibration
	Steering angle neutral point (Initialize panoramic view monitor system)	Panoramic view monitor system	Click here for Initialization Click here for Calibration
	Steering angle neutral point (Initialize intelligent clearance sonar system)	Intelligent clearance sonar system	Click here
Air conditioning amplifier assembly*1	Reset Air Conditioning Information Learning Air Conditioning Information	Stop and start system	Click here
Air conditioning amplifier assembly	Initialize servo motor (Air conditioning system)	DTCs are stored	Click here

*1: w/ Stop and Start System

*2: When performing learning using the GTS.

Click here

PROCEDURE

REMOVE AIR CONDITIONER UNIT ASSEMBLY

Click here
REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
1. Remove in this Direction
  
  Remove the screw.
2. Disengage the guide to remove the air conditioning amplifier assembly as shown in the illustration.