AIR CONDITIONING PANEL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during air conditioning panel removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	LKA/LDA System	Click here
		Intelligent clearance sonar system*3
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking assist monitor system (w/ Parallel parking assist function)	Click here
		Parking assist monitor system (w/o Parallel parking assist function)	Click here
		Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here
Replacement of radio receiver assembly (w/ Parallel parking assist function)	Parking assist monitor system initialization	Parking assist monitor system (w/ Parallel parking assist function)	Click here for Initialization Click here for Calibration
Replacement of radio receiver assembly (w/ G-BOOK)	Vehicle contract setting	G-BOOK service Emergency call service	Click here for Initialization1 Click here for Initialization2
Replacement of radio receiver assembly (w/ G-BOOK)	Download necessary data	Some G-BOOK service content will be unavailable.	Click here for Registration1 Click here for Registration2

*1: w/ Telematics Transceiver for G-BOOK

*2: w/o Telematics Transceiver for G-BOOK

*3: When performing learning using the GTS.

Click here

PROCEDURE

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Click here
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Click here
REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT

Click here
REMOVE LOWER INSTRUMENT FINISH PANEL SUB

Click here
REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER

Click here
REMOVE CLOCK ASSEMBLY

Click here
REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Click here
REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Click here
REMOVE NO. 1 RADIO BRACKET (w/ Navigation System)

for LHD:

Click here

for RHD:

Click here
REMOVE NO. 2 RADIO BRACKET (w/ Navigation System)

for LHD:

Click here

for RHD:

Click here
REMOVE HARD DISC DRIVE (w/ Navigation System)

w/ Telematics Transceiver:

Click here
REMOVE RADIO RECEIVER ASSEMBLY