FRONT EVAPORATOR TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front evaporator temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	LKA/LDA System	Click here
		Intelligent clearance sonar system*1
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking assist monitor system (w/ Parallel parking assist function)	Click here
		Parking assist monitor system (w/ Parallel parking assist function)	Click here
		Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here
Removal/installation of the spiral cable with sensor sub-assembly	Steering angle neutral point (Initialize parking assist monitor system) Steering angle setting	Parking assist monitor system (w/ Parallel parking assist function)	Click here for Initialization Click here for Calibration
		Parking assist monitor system (w/o parallel parking assist function)	Click here for Initialization Click here for Calibration
	Steering angle neutral point (Initialize panoramic view monitor system)	Panoramic view monitor system	Click here for Initialization Click here for Calibration
	Steering angle neutral point (Initialize intelligent clearance sonar system)	Intelligent clearance sonar system	Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE

REMOVE BLOWER ASSEMBLY

Click here
REMOVE AIR CONDITIONING HARNESS ASSEMBLY

Click here
REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

Click here
REMOVE HEATER GROMMET (for LHD)

Click here
REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY

Click here
REMOVE COOLING UNIT PARTS

Click here
REMOVE COOLER EXPANSION VALVE

Click here
REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

Click here
REMOVE NO. 1 COOLER THERMISTOR
1. except 8AR-FTS:
  1. Remove the No. 1 cooler thermistor.
2. for 8AR-FTS:
  1. Remove the No. 1 cooler thermistor.