REAR CENTER SEAT OUTER BELT ASSEMBLY(w/o Rear No. 2 Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear center seat outer belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Intelligent clearance sonar system*1
Pre-Crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:


  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

B005NS4

PROCEDURE


  1. REMOVE REAR SEAT ASSEMBLY RH

    Click here

  2. REMOVE REAR SEAT COVER CAP RH (for Manual Seat)

    Click here

  3. REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE RH (for Manual Seat)

    Click here

  4. REMOVE POWER SEAT SWITCH ASSEMBLY (for Power Seat)

    Click here

  5. DISCONNECT SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD

    Click here

  6. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD

    Click here

  7. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

    B005NOJ

    1. Remove the bolt and disconnect the anchor of the rear center seat outer belt assembly.

  8. REMOVE REAR SEATBACK COVER RH

    Click here

  9. REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY RH

    Click here

  10. REMOVE SEAT BELT ANCHOR COVER CAP

    Click here

  11. REMOVE REAR SEAT SHOULDER BELT COVER

    Click here

  12. REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD

    Click here

  13. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY

    B005Q30

    1. Remove the 2 nuts and rear center seat outer belt assembly.