REAR CENTER SEAT OUTER BELT ASSEMBLY(w/ Rear No. 2 Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear center seat outer belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	LKA/LDA System	Click here
		Intelligent Clearance Sonar System*1
		Pre-crash Safety System
		Lighting System (EXT) Cornering lights
		Adaptive High Beam System
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and Start System	Click here
	Memorize steering angle neutral point	Parking Assist Monitor System (w/ Parallel Parking Assist Function)	Click here
		Parking Assist Monitor System (w/o Parallel Parking Assist Function)	Click here
		Panoramic View Monitor System	Click here
	Initialize back door lock	Power Door Lock Control System	Click here
	Reset back door close position	Power Back Door System	Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here
Wear protective gloves. Sharp areas on the seat frame may injure your hands.

PROCEDURE

REMOVE REAR NO. 1 SEAT ASSEMBLY RH

Click here
REMOVE REAR SEAT COVER CAP RH

Click here
REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE RH

Click here
REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY RH

Click here
REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD

Click here
REMOVE REAR NO. 1 SEAT RECLINING ADJUSTER INSIDE COVER

Click here
DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
1. Remove the bolt to disconnect the anchor of the rear center seat outer belt assembly.
REMOVE REAR SEATBACK COVER RH

Click here
REMOVE REAR SEATBACK BOARD CARPET ASSEMBLY RH

Click here
REMOVE REAR SEAT UPPER RECLINING COVER RH

Click here
REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH

Click here
REMOVE SEAT BELT ANCHOR COVER CAP

Click here
REMOVE REAR SEAT SHOULDER BELT COVER

Click here
REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD

Click here
REMOVE REAR SEATBACK EDGE PROTECTOR

Click here
REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY
1. Remove the 2 nuts.
2. Disengage the 2 guides to remove the rear center seat outer belt assembly.