STEREO JACK ADAPTER ASSEMBLY(for Rear No. 1 Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headphone terminal removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Intelligent Clearance Sonar System*1
Pre-crash Safety System

Lighting System (EXT)


  • Cornering lights
Adaptive High Beam System
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and Start System

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic View Monitor System

Click here

Initialize back door lock Power Door Lock Control System

Click here

Reset back door close position Power Back Door System

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:


  • B005NS4

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the seat frame may injure your hands.

PROCEDURE


  1. REMOVE REAR NO. 1 SEAT ASSEMBLY RH

    Click here

  2. REMOVE REAR SEATBACK COVER

    w/ Cover:

    Click here

  3. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY

    Click here

  4. REMOVE CENTER ARMREST HINGE COVER LH

    Click here

  5. REMOVE NO. 1 SEAT ARMREST ASSEMBLY

    Click here

  6. REMOVE ARMREST ASSEMBLY

    Click here

  7. REMOVE CENTER ARMREST HINGE COVER RH

    Click here

  8. REMOVE REAR SEAT CENTER ARMREST ASSEMBLY

    Click here

  9. REMOVE REAR SEAT CENTER ARMREST COVER

    Click here

  10. REMOVE CUP HOLDER ASSEMBLY

    Click here

  11. REMOVE REAR SEAT CENTER ARMREST DOOR SUB-ASSEMBLY

    Click here

  12. REMOVE NO. 2 REAR SEAT CENTER ARMREST BOX

    Click here

  13. REMOVE HEADPHONE TERMINAL LH


    1. B005LGX

      Disconnect the connector.

    2. Disengage the 3 claws and remove the headphone terminal LH.

  14. REMOVE HEADPHONE TERMINAL RH

    Tech Tips

    Use the same procedure as for the LH side.