RADIO RECEIVER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during radio receiver assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Pre-crash safety system

Lighting system (EXT)


  • Cornering lights
Adaptive high beam system
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking assist monitor system (w/ Parallel parking assist function)

Click here

Parking assist monitor system (w/o Parallel parking assist function)

Click here

Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

Replacement of radio receiver assembly (w/ Parallel parking assist function) Parking assist monitor system initialization Parking assist monitor system (w/ Parallel parking assist function)

Click here for Initialization

Click here for Calibration

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT

    Click here

  6. REMOVE LOWER INSTRUMENT FINISH PANEL SUB

    Click here

  7. REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER


    1. B005L3F

      Remove the 2 bolts.

    2. B005O2IC01
      B005OOA Remove in this Direction

      Pull the radio receiver assembly with register toward the rear of the vehicle to disengage the 7 clips.

    3. Disconnect each connector and remove the radio receiver assembly with register.

  8. REMOVE CLOCK ASSEMBLY

    Click here

  9. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. B005LR9C01
      *a Protective Tape
      B005M6U Insert Screwdriver Here
      B005OOA Remove in this Direction

      Using a screwdriver, disengage the 4 claws and remove the No. 3 instrument panel register assembly as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

  10. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    Tech Tips

    Use the same procedure as for the No. 3 instrument panel register assembly.

  11. REMOVE RADIO RECEIVER ASSEMBLY