STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA /LDA system

Click here

Intelligent clearance sonar system*1
Pre-crash safety system

Lighting system (EXT)


  • Cornering lights
Adaptive high beam system
Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic view monitor system

Click here

Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. Disconnect each connector from the spiral cable with sensor sub-assembly.

    2. A01VUZ2C01
      *a Matchmark

      Remove the steering wheel assembly set nut.

    3. Put matchmarks on the steering wheel assembly and steering main shaft.

    4. A01VXYVC01
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE CRUISE CONTROL MAIN SWITCH

    Click here

  5. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  6. REMOVE LOWER NO. 1 STEERING WHEEL BOSS COVER (w/ Shift Paddle Switch)

    U661F: Click here

    U881F: Click here

  7. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)

    U661F: Click here

    U881F: Click here

  8. REMOVE NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)

    U661F: Click here

    U881F: Click here