STARTER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Memorize steering angle neutral point	LKA/LDA System	Click here
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking Assist Monitor System (w/ Parallel Parking Assist Function)	Click here
		Parking Assist Monitor System (w/o Parallel Parking Assist Function)	Click here
		Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here
Replacement of starter assembly	Clear Number of Starter Operations	Stop and start system	Click here
Replacement of battery	Integrated Current Value Initialization Switch Battery Type	Stop and start system	Click here

PROCEDURE

PRECAUTION
Note
- After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
  
  Click here
- When the starter assembly is replaced, "ST relay" and "ST NO. 2 relay" must be also replaced.
REMOVE COOL AIR INTAKE DUCT SEAL

Click here
REMOVE INLET AIR CLEANER ASSEMBLY

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE BATTERY
1. Disengage the 2 claws to open the battery terminal cap.
2. Loosen the nut and disconnect the cable from the positive (+) battery terminal.
3. Remove the bolt, nut and battery clamp sub-assembly.
4. w/ Battery Insulator:
  1. Remove the battery insulator.
5. Remove the battery and battery tray.
6. Remove the battery clamp bolt from the battery carrier.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Click here
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Click here
REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Click here
REMOVE AIR CLEANER BRACKET
1. Remove the 2 bolts and air cleaner bracket.
REMOVE STARTER ASSEMBLY
1. Remove the 2 bolts and disconnect the wire harness.
2. Disconnect the starter assembly connector.
3. Remove the terminal cap.
4. Remove the nut and disconnect terminal 30.
5. Remove the 2 bolts and starter assembly.