FUEL FILTER REPLACEMENT

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel filter removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point LKA/LDA System

Click here

Intelligent clearance sonar system*1
Pre-crash safety system

Lighting system (EXT)


  • Cornering lights
Adaptive high beam system
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)

Click here

Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

Replacement of fuel pump Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

w/ Canister Pump Module: Click here

w/o Canister Pump Module: Click here

*1: When performing learning using the GTS.
Click here Click here

Note


  • Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.

  • When replacing the fuel filter, replace it together with the fuel suction plate sub-assembly.

B005PLCC01
*a Tube

PROCEDURE


  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY

    Click here

  3. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY

    Click here

  4. REMOVE FUEL PUMP FILTER

    Click here

  5. REMOVE FUEL PUMP

    Click here

  6. REMOVE FUEL MAIN VALVE ASSEMBLY

    Click here

  7. REMOVE NO. 1 FUEL SUCTION SUPPORT


    1. B005OKXC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter.

  8. INSTALL NO. 1 FUEL SUCTION SUPPORT


    1. Engage the 2 claws to install the No. 1 fuel suction support to the fuel filter.

  9. INSTALL FUEL MAIN VALVE ASSEMBLY

    Click here

  10. INSTALL FUEL PUMP

    Click here

  11. INSTALL FUEL PUMP FILTER

    Click here

  12. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY

    Click here

  13. INSTALL FUEL SENDER GAUGE ASSEMBLY

    Click here

  14. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here