HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR


    1. B005MUGC02
      *a Torque Wrench Fulcrum Length

      Using SST, install the heated oxygen sensor to the center exhaust pipe assembly (TWC: Rear Catalyst).

      SST
      09224-00011
      Torque
      Specified tightening torque
      44 N*m (449 kgf*cm, 32 ft.*lbf)

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 260 mm (10.2 in.)):

        39 N*m (398 kgf*cm, 29 ft.*lbf)

    2. Engage the 4 wire harness clamps.

    3. Connect the heated oxygen sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here

  3. INSTALL FRONT FLOOR COVER LH


    1. B005L6YC01
      B005NIZ Bolt
      B005LWS Screws

      Engage the 2 clips (B) to install the front floor cover LH.

    2. Install the clip (A), 2 screws and 4 bolts.