SPIRAL CABLE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the spiral cable with sensor sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Correct the steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

Removal/installation of the spiral cable with sensor sub-assembly Steering angle neutral point (Initialize parking assist monitor system) Parking assist monitor system

Click here

PROCEDURE


  1. DISABLE AUTO TILT AWAY FUNCTION


    1. Disable the autoaway/return function by changing the customize parameter.

      Click here

      Note

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off.

  2. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  3. INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. Check that the front wheels are facing straight ahead.

    2. Check that the spiral cable with sensor sub-assembly is center position.

      OK
      The connector is at the top.
      The matchmarks are aligned.
      The top of the flat cable U-turn can be checked from the check window.
      B002D1JC02
      *A w/o Steering Heater *B w/ Steering Heater
      *a Check Window *b Matchmark
      *c Top of Flat Cable U-turn - -

      Note

      If the result is not as specified, it is possible that the spiral cable with sensor sub-assembly is broken. Replace the spiral cable with sensor sub-assembly with a new one.

  4. REMOVE STEERING COLUMN COVER

    Click here

  5. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

    • Do not rotate the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      B002DW2
    3. B002DQQC02
      *a Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. Disconnect the connectors.

    5. B002D7C

      Disengage the claws to remove the spiral cable with sensor sub-assembly.