STOP LIGHT SWITCH INSTALLATION

PROCEDURE


  1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. A005NZ1

      Insert the stop light switch assembly until the threaded sleeve hits the pedal.

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    2. A005O6NE01

      Turn the stop light switch assembly 1/4 clockwise to install it.

      Torque
      1.5 N*m (15 kgf*cm, 13 in.*lbf) or less

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    3. Connect the connector.

    4. Check the protrusion of the plunger.

      Protrusion of the Plunger
      Area Measurement
      a 0.6 to 2.6 mm (0.0236 to 0.102 in.)

    5. If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.

      for LHD
      Click here Click here
      for RHD
      Click here Click here

      Note

      Do not depress or support the brake pedal.

  2. INSTALL NO. 1 AIR DUCT

    Click here

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. INSTALL COWL SIDE TRIM BOARD LH

    Click here

  5. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here