DRIVING SUPPORT BUZZER(for RHD) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the driving support buzzer (pre-collision city buzzer) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point

  • Lane departure alert system (w/ Steering Control)

  • Simple intelligent parking assist system*1

  • Toyota parking assist sensor system*1

  • Pre-collision system

Click here

Initialize back door lock Power door lock control system

Click here


PROCEDURE


  1. REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY

    Click here

  2. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

    Click here

  3. REMOVE STEREO OPENING COVER WITH BRACKET (w/ Cover)

    Click here

  4. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)

    Click here

  5. REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

    Click here

  6. REMOVE DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)


    1. A005O8J

      Disengage the clamp.

    2. Disconnect the connector to remove the driving support buzzer (pre-collision city buzzer).

      Note

      If the driving support buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.